Yesterday, I’d prepared an all new X7-2M. During the setup process / network configuration (using VLAN), I ran into a problem: Despite the network configuration was setup absolutely correct, any try to connect to the system from a jumphost was unsuccessful.
Long story short: If You want to use the SFP28 (Fiberchannel) ports an ODA X7 offers, You have to do some config changes, to make it work.
First of all: do a firmware upgrade to version 20.08.01.14 or above.
Next, configure the nic / nics to force the speed to 10000 and turn off autonegotiation.
The firmware as well as a detailed description of all necessary steps can be found in MOS Note 2373070.1 ‘Using the onboard SFP28 ports on an ODA X7-2 server node’
Very nice post here and thanks for it .I always like and such a super contents of these post.Excellent and very cool idea and great content of different kinds of the valuable information's.
ReplyDeleteGood discussion. Thank you.
Anexas
Six Sigma Training in Abu Dhabi
Six Sigma Training in Dammam
Six Sigma Training in Riyadh